CONTENTSTART

Do I Really Need a Boom Vang?

We get a lot of great questions through our Ask the Expert portal and sometimes they make for great articles. Here are Quantum's David Flynn's insights for Mark A. and everyone else who's wondered about how to properly use the boom vang.

I’ve barely ever used my boom vang. Do I really need one?

- Mark A.

Absolutely! The boom vang can be a misunderstood sail control. It takes over the job of pulling down on the boom once the mainsheet is eased. Upwind, the mainsheet pulls down as soon as the boom is over the traveler. Controlling the boom height determines twist, or the shape of the mainsail leech.

If you don’t use the boom vang in all but the lightest conditions, the boom will rise up as it is eased out and the sail will twist off, spilling power out of the top of the sail. This is okay when you have too much heel and helm, but not when you need power. Not taking advantage of your boom vang also limits how far out you can ease the sail. If the top is twisted off, it will run up against the upper shrouds and wrap itself around the stay, which prevents you from letting out the sail as far as you would like. The golden rule of thumb: Use enough vang to keep the top batten parallel to the boom. If it is too tight, the top telltale will stall.

There are a few exceptions however when it comes to boom vang use. The first has to do with multihull boats, which have a traveler that runs the entire width of the boat. With this type of boat, letting the traveler down allows the mainsheet to continue to do the job of pulling down and controlling twist. The length of the traveler lets the boom go a long way out before it starts to lift. Also, most multihulls have upper shrouds that are quite far aft, which prevents easing the mainsheet very far. A vang still helps, however, as it allows maximum ease on the boom before the shrouds become an issue.

The other exception has to do with high-performance planing boats that use asymmetrical spinnakers (Melges 24s, 32s, and C&C 30s, etc). To promote planing and to match the leech of the asymmetrical spinnaker when reaching high angles, a huge amount of twist is required. With this type of boat, you have to ease the vang (until it is almost off) to induce twist, then overshoot and pump the mainsail to promote planing.

If you’d like to know a bit more about mainsail twist (another sailor had a question about it, too), read more here.

Request a quote Ask our experts

The Discussion

David Trotter
David Trotter

We would be very happy to supply branded muggi drinks carriers made from recycled waste ocean plastic! www.muggi.co.uk

EXCLUDESTART
EXCLUDEEND
CONTENTEND
This website uses cookies and collects usage statistics. Privacy Policy